Evaporative Cooling Towers

The specific application will largely determine which bac cooling tower is best suited for a project.

Evaporative cooling towers.

Long lasting with the non rusting uv protected reinforced fiberglass shell. Since it is relatively new on the market not many people have known it yet. Evaporative cooling systems use the same principle as perspiration to provide cooling for machinery and buildings. In hot dry climates evaporative cooling towers will cool outdoor air and circulate it to a space or building.

Cooling towers provide evaporative cooling for many types of systems. Capacities from 45 to 540 tons. The evaporative cooling tower is by far the most environmentally friendly and cost effective among the different types of cooling towers. At cooling technology inc we may design these to be stacked or split into two sections and for.

With single point wiring and factory testing evaporative cooling towers provide reduced field. Evaporative cooling towers made of durable uv protected fiberglass with a counter air flow design. Wet cooling towers operate on the evaporative cooling principle but are optimized to cool the water rather than the air. A well maintained tower enables the entire cooling system to perform at optimum efficiency by conserving both energy and water.

An evaporative heat rejection device enables building owners and operators to take advantage of the operating cost savings inherent in water cooled systems. The working fluid and the evaporated fluid usually water are one and the same. Evaporative cooling is the process in which the evaporation of water removes heat from a system. An evaporative cooling tower also commonly referred to as swamp coolers is one of the primary types of cooling towers.

Wet cooling towers or open circuit cooling towers operate on the principle of evaporative cooling. Evaporating water at the top of a cooling tower creates a downdraft of cooler air that can then be circulated to a specific space or area. When the standard is close but not. Specific application assistance is available through your local bac representative.

Application in cooling towers cooling and hvac units typically use evaporative cooling through either counterflow or crossflow systems this can be further broken down to direct and indirect evaporative cooling. Cooling towers can often be found on large buildings or on industrial sites. Closed circuit cooling towers or fluid coolers pass the working fluid through a tube bundle upon which clean water is sprayed and a fan induced draft applied. Cooling towers are structures for cooling water or other heat transfer media to near ambient wet bulb temperature.